5
Installation -
continued
5.
Drill the holes for the two chimney brackets and the two safety holes. Place wall plugs in each hole. Fix
the upper chimney bracket to the wall using two ST4x40mm screws. Place the appliance back on the
fixing bracket and fasten in place using two ST4x30mm safety screws.
6.
Only if ducting
- Mark and cut out the hole in the ceiling / wall to fit the ducting (160mm dia max).
Warning: Chimney depth is 270mm. Ensure no part of the hole is greater than 265mm from the wall.
7.
Connect and secure the ducting (use duct tape if required).
8.
Place the chimney assembly back onto the appliance (take care the power cord is accessible & not
trapped by the chimney). Fix the lower chimney to the wall using two ST4x40mm screws.
9.
Extend the upper chimney to the ceiling and secure in place with two ST4x8mm screws (take care to
tighten all screws when lined up).
10.
Replace the filters. Remove any protective plastic (including from the filters). Connect to the power
source.
Recirculation mode
1.
This unit can be installed to operate in recirculation mode where ducting is not a chosen/desired or practical
option. There are recirculation grilles fitted on each side of the upper chimney which allow the cleansed air
to return to the kitchen. Ensure that the side outlet grilles are not obstructed. Even a partial obstruction
will restrict the efficiency of the rangehood.
2.
Replace aluminium filters with charcoal filters (see pg 7 for part numbers).