7
Cleaning and maintenance
Fault
Cause
Solution
Lights do not work, but fan
works
The LED damaged
Contact Service Department
LED wiring connection poor
LED switch damage
Lights work, but fan does
not work
Motor bearings damage
Contact Service Department
Motor burn out
Motor control switch damage
Light does not work, motor
does not work
Plug contact outlet bad
Fix or change
Power wire cut off
Change power wire
Switch damage
Contact Service Department
Appliance vibrates
violently
Motor screw loosen
Contact Service Department
Fixing brackets loose
Tighten the fixing brackets
Insufficient suction
The distance between the body and the
cooktop too long
Readjust the distance
Cross-ventilation too strong or too
closed in the kitchen
Reduce cross-ventilation or
open the window
Exhaust pipe too long
Adjust the length of pipe
Air outlet valve not open
Check the valve if flexible
The outside wind is too strong
Shield outlet from wind
General Maintenance
Switch off the rangehood before cleaning or maintenance.
To prevent surface damage never use abrasive or oil based liquid cleaners. To clean the
surfaces of the appliance, use mild detergent and warm water. In areas of high humidity
and coastal environments cleaning should be carried out frequently.
Warning: a build up of oil may occur if the compact canopy is not cleaned regularly.
Filter Maintenance
To maintain efficiency, the filters should be removed regularly (approximately monthly), and washed using hot
soapy water or the dishwasher.
Some discolouration of the filter frame may occur if washed in the dishwasher.
Rangehoods fitted with charcoal filters are designed to remove grease and odours from cooking vapours prior to
the cleansed air re-entering the kitchen (when the rangehood is in recirculation mode). Charcoal filters should be
replaced every two to four months depending on use.
Fully saturated charcoal filters can become a barrier to air movement therefore limiting rangehood
performance. In the event of fire, grease laden filters could be flammable and therefore regular
replacement is recommended. In ducted installations, conventional aluminium filters are recommended.
Replacement of LED Lamps
The LED lamps cannot be replaced by the consumer. If any faults occur, please ring your nearest Service
Department
.
Replacement parts
o
Charcoal filter CF260
For any other problems please call help line on NZ 0800 760 667 or AUS 1800 648 556
