21
Cleaning and Maintenance
WARNING:
Turn your mains power supply off and remove the plug from the socket before carrying out
maintenance and cleaning your machine.
Turn off the cold-water supply before starting maintenance and cleaning your machine.
CAUTION:
Do not use solvents, abrasive cleaners, glass cleaners or all-purpose cleaning agents to clean your
Washer Dryer. They may damage the plastic surfaces and other components with the chemicals they contain.
Water Inlet Filters
Water inlet filters prevent dirt and foreign materials from entering your machine. We recommend that these filters are
cleaned when your machine is unable to receive sufficient water, although your water supply is on and the tap is open.
We recommend that you clean your water inlet filters every 2 months.
•
Unscrew the water inlet hose from the
•
Washer Dryer.
•
To remove the water inlet filter from the water inlet valve, use a pair of long- nosed pliers to gently pull on the
plastic bar in the filter.
•
A second water inlet filter is located in the tap end of the water inlet hose. To remove the second water inlet
filter, use a pair of long-nosed pliers to gently pull on the plastic bar in the filter.
•
Clean the filter thoroughly with a soft brush and wash with soapy water and rinse thoroughly. Re-insert the
filter by gently pushing it back into place.
CAUTION:
The water inlet filters can become clogged due to water quality or lack of required maintenance
and may break down. This may cause a water leak. Any such breakdowns are out of the scope of the warranty.
Detergent Drawer
The use of detergent may cause residual build up in the detergent drawer over time. We recommend that you
remove the drawer every 2 months to clean the accumulated residue.
To remove the detergent drawer:
•
Pull the drawer forwards until it is fully
•
extended.
•
Gently press down on the detergent drawer (as shown above) and pull the drawer from its housing.
•
Clean the drawer with water and a soft
•
brush.
•
If there is any residue in the drawer housing, remove with a soft brush. Take care to prevent any residue from
dropping into the machine.
•
Dry the drawer thoroughly and slide it back into the housing
