Dust extraction
For your own health and to avoid fire risk and dust explosion, it is recommended to
connect the machine to a dust extraction system.
The 160 mm outlet on the dust chute need to be connected to a dust extractor,
powerfull enough to obtain an airflow of at least 20 m/sec., measured at the outlet on
the machine
Changing and setting of the planer knives (fig. 4)
In order to turn the planer arbor by hand, push the brake release switch (fig.3, S4.1)
the warning light L1 will light.
Now the dust-safety hood can be opened by pulling the handle situated at the side of
the hood.
To avoid serious injuries when handling planer knives, the wear of safety gloves
is highly recommended: even blunt knives can cause serious damage to your
hands !.
Make sure both planer knives and jib strips are well cleaned before putting them into
the slots in the planer arbor.
Take care of the springs underneath the knives, and see to it that they do not stay
blocked inside their seats in the arbor.
Now put the cleaned planer knive into the groove, pushing the knive down with the
adjustment gauge(fig.4)), and tighten the bolts.
Repeat above for the other planer knives.
Make sure all knives are set at exactly the same height.
Before starting up the machine check again if all bolts are well tightened, and then
push the brake release switch (fig.3,S4.1) the warning light L1 must dim.
fig. 4
Magnetic knife
setter jigs
12
Summary of Contents for D 630
