ROBLIN DECLIC 609, Instructions For Installation Manual

5

GB

Thank you for buying a Roblin product which has been manufactured to the highest quality standards to
meet your requirements.
We recommend you carefully read this booklet in which you will find instructions for installation, hints for
use and maintenance.

1

ELECTRICAL

•

This cooker hood is fitted with a 3-core mains cable with a standard 10/16A earthed plug.

•

Alternatively the hood can be connected to the mains supply via a double-pole switch having 3mm

minimum contact gap on each pole.
•

Before connecting to the mains supply ensure that the mains voltage corresponds to the voltage on

the rating plate inside the cooker hood.
•

Technical Specification: Voltage 220-240, single phase ~50/60Hz.

2

 INSTALLATION ADVICE

•

Ensure the cooker hood is fitted in compliance with the recommended fixing heights.

•

To ensure the safe operation of this cooker hood, we recommend that the hood should not be fitted

below 65cm (for electric) or (70cm for gas) the measurements taken from the surface of the cooking
appliance to the underside of the cooker hood.

•

It is a possible fire risk if the hood is not sited as recommended.

•

To ensure the best results, the cooking fumes should be able to rise naturally towards the inlet grilles

on the underside of the cooker hood and the cooker hood should be positioned away from doors and
windows, which will create turbulence.

•

Ducting

•

If the room where the hood is to be used contains a fuel-burning appliance such as a central heating

boiler then its flue must be of the room sealed or balanced flue type.

•

If other types of flue or appliances are fitted ensure that there is an adequate supply of fresh air to the

room. Ensure the kitchen is fitted with an airbrick, which should have a cross-sectional measurement
equivalent to the diameter of the ducting being fitted, if not larger.

•

The ducting system for this cooker hood must not be connected to any existing ventilation system,

which is being used for any other purposes or to a mechanically controlled ventilation ducting.

•

The ducting used must be made from fire retardant materials and the correct diameter must be used,

as incorrect sized ducting will affect the performance of this cooker hood.

•

When the cooker hood is used in conjunction with other appliances supplied with energy other than

electricity, the negative pressure in the room must not exceed 0.04 mbar to prevent the fumes from
combustion being drawn back into the room.

•

The appliance is for domestic use only and should not be operated by children or people who are

infirm without supervision.

•

This appliance must be positioned so that the wall socket is accessible.

3

FITTING

Any permanent electrical installation must comply with the latest regulations concerning this type of
installation and a qualified electrician must carry out the work. Non-compliance could cause serious
accidents or injury and would deem the manufacturers guarantee null and void.

IMPORTANT - 

The wires in this mains lead are coloured in accordance with the following code :

 green / yellow : earth

blue : neutral

  brown : live

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows.
-

The wire which is coloured green and yellow must be connected to the terminal in the plug which is
marked with the letter 

E

 or by the earth symbol  

      or coloured green or green and yellow..

-

The wire  which is coloured blue must be connected to the terminal which is marked with the letter 

N 

or

coloured black.

-

The wire  which is coloured brown must be connected to the terminal which is marked with the letter 

L 

or

coloured  red.