17
GB
• Drill ø 8 mm holes at all the centre points marked.
• Insert the wall plugs 11 in the holes.
• Fix the brackets using the 12a screws supplied.
• Fix the back panel (where present) using the 12a screws supplied.
Mounting the hood body
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the hood to the chimney using either a flexible or rigid
pipe ø 150 or 120 mm, the choice of which is left to the installer.
RECIRCULATION VERSION AIR OUTLET
• Screw the two screws 12d (M4 x 25) supplied
onto the brackets 7.1.
• Hook the hood body onto bracket 7.1, centring it
around the vertical line.
• Use the adjusting screws 12d underneath the
hood to level the hood body.
• To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet.
• Fix the pipe in position using sufficient pipe
clamps (not supplied).
• Remove any activated charcoal filters.
• Push fit the air outlet fitting 15 onto the air outlet
of the hood body.
• The air outlet directional grills must be fitted after
the lower outlet duct 2.2 has been installed
• Ensure that the activated charcoal filters have
been inserted.
12.d
7.1
ø 120
ø 150
9
15
