ROBLIN Escale Murale, Instructions For Use And Installation

10

         USE UL HINTS

To obtain the best performance it is advisable to switch ‘ N’ the cooker hood a few minutes (in the

boost setting) before you start cooking and you should leave it running for approximately 15 minutes after

nishing.

IM ORTANT  NE ER  O  LAM

 COOKIN  UN ER THIS COOKER HOO

S

  O

E

         MAINTENANCE

Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.

The cooker hood must be kept clean  a build up of fat or grease can be a  re hazard.

Casing

ipe the cooker hood frequently with a clean cloth, which has been immersed in warm water containing

a mild detergent and wrung out.

Never use excessive amounts of water when cleaning particularly around the control panel.

Never use scouring pads or abrasive cleaners.

 Always wear protective gloves when cleaning the cooker hood.

M

The metal grease  lters absorb grease and dust during cooking to help keep the cooker hood clean

inside. The grease  lters should be cleaned once a month or more frequently if the hood is used for more

than 3 hours per day.

T  

Remove the metal grease  lters one at a time by releasing the catches on the  lters  the  lters can

now be removed.

The metal grease  lters should be washed, by hand, in mild soapy water or in a dishwasher.

 Allow to dry before replacing.

A

 C

The charcoal  lter cannot be cleaned. The  lter should be replaced at least every three months or more

frequently if the hood is used for more than three hours per day.

T  

Remove the metal grease  lters.

Press against the two retaining clips, which hold the charcoal  lter in place and this will allow the  lter

to drop down and be removed.

Clean the surrounding area and metal grease  lters as directed above.

Insert the replacement  lter and ensure the two retaining clips are correctly located.

Replace the metal grease  lters.

Extraction tube

.

Check every 6 months that the dirty air is being extracted correctly. Comply 

-

tions 

with regard to the extraction of ventilated air.

Lighting

.

If the lamp fails to function check to ensure it is  tted correctly into the holder. If lamp failure has occurred

then it should be replaced with identical replacement.

GB