ROBLIN LINEAR CENTRALE, Instructions For Installation Manual

9

Proceed by repeatedly pressing the LED button 5 (Boost speed):

Two flashes of the LED button 1 & 5 = 5 minutes delay.

Three flashes of the LED button 1 & 5 = 10 minutes delay.

Four flashes of the LED button 1 & 5 = 15 minutes delay.

One flash of the LED button indicates the function is switched ‘OFF’.

You can switch the cooker hood ‘ON’ and adjust the speed. The LED buttons 2, 3 and 4 will flash to

indicate the fan motor is switched ‘ON’ and which speed has been selected.

One flash = stop after 15 minutes.

Two flashes = stop after 10 minutes.

Three flashes = stop after 15 minutes.

• Indication of saturation of the metal grease filters :

After 

200 hours 

use, 

one quick flash of the LED 1 

will indicate that you must clean the metal grease

filters. (See chapter on ‘Maintenance’).

To reset the 200 hours timer back to zero requires the motor and lights must be switched ‘OFF’; then and

proceed as follows:

Press the LED button ‘+’ for 3 to 4 seconds and the LED lights 1,2,3, 4 and 5 will flash to confirm the
programme has been reset to zero.

8GB

• Indication of saturation of the active charcoal filter :

After 

400 hours 

use, 

two quick flash of the LED 1 

will indicate that you must replace the active char

-

coal

filter and clean the metal grease filters. (See chapter on ‘Maintenance’).

To reset the 400-hour timer the motor and lights must be switched ‘OFF’.

Push the LED button ‘+’ for 10 seconds.

One flash of the LED lights 1,2,3,4 and 5 = function is switched ‘OFF’.

Two flashes of the LED lights 1,2,3,4 and 5 = function is switched ‘ON’.

Instructions for replacing the active charcoal filter are given in the chapter on ‘Recycling’.

• Pre-set remote control handset 

Your cooker hood is supplied with a deactivated remote control receiver. To use the cooker hood with a 

remote control re-programme the hood as follows: 

Press the LED button (Lighting) ‘1’ while the motor and lights are switched ‘OFF’, until the LED lights 1 will 
flash to confirm the programme has been activated : 

One flash of the LED lights 1 = function is switched ‘OFF’. 
Two flashes of the LED lights 1 = function is switched ‘ON’. 

Caution, the remote control handset must be fitted with standard LR03-AAA size 1.5V zinc-carbon alkaline 

batteries as illustrated Fig. 7. These batteries should give a long life and constant discharge throughout 

their life. These batteries must be disposed of properly and could explode if damaged or exposed to heat. 

Do not dispose of on fire. 

Dispose of batteries in the appropriate sort container to protect the environment.

• Setup Process 
Modification: How to adjust the internal microprocessor data to suit the type of motor fitted to this 
appliance and the supply frequency of 50 or 60 Hz.. 

1 - Disconnect the cooker hood from the mains supply. 
2 - Push the button 0/1 MOTOR. 
3 - Reconnect the mains supply while pushing the button 0/1 MOTOR for at least 2 seconds. 

4 - Release the button 0/1 MOTOR (the Leds flash for about 3 seconds : capacity’s confirmation SETUP 
PROCESS). 

5 - While the LED is flashing select the motor type used while pushing one of the 5 buttons in accordance 
with the following: 
BUTTON 0/1 Light    : Motor EBM PRO 220-240 V AC 50 Hz / 220 V AC 60 Hz. 

GB