ROBLIN LINEAR CENTRALE, Instructions For Installation Manual

10

BUTTON 0/1 Motor   : Motor FABER 8/28 e 8/50 220-240 V AC 50 Hz / 220 V AC 60 Hz. 
BUTTON Speed ( - ) : Motor EBM MISTRAL 220-240 V AC 50 Hz / 220 V AC 60 Hz. 
BUTTON Speed (+ ) : Motor EBM PRO 220-240 V AC 50 Hz / 220 V AC 60 Hz. 
BUTTON Intensive speed : Motor FABER K40-K50 220-240 V AC 50 Hz / 220 V AC 60 Hz. 
N.B. : If you have not selected a motor type while the LED is flashing the microprocessor will automatically 
select the default motor EBM PRO 220 - 240 V AC 50 Hz / 220 V AC 60 Hz. 

  5      USEFUL HINTS

• To obtain the best performance it is advisable to switch ‘ON’ the cooker hood a few minutes (in the

boost setting) before you start cooking and you should leave it running for approximately 15 minutes after

finishing.

• 

IMPORTANT: NEVER DO FLAMBÉ COOKING UNDER THIS COOKER HOOD

• 

Do not leave frying pans unattended during use as over-heated fat and oil might catch fire.

• 

Do not leave naked flames under this cooker hood.

• 

Switch ‘OFF’ the electric and gas before removing pots and pans.

• 

Ensure heating areas on your hotplate are covered with pots and pans when using the hotplate

and cooker hood simultaneously.

  6      MAINTENANCE

Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.

The cooker hood must be kept clean; a build up of fat or grease can be a fire hazard.

Casing

• Wipe the cooker hood frequently with a clean cloth, which has been immersed in warm water containing

a mild detergent and wrung out.

• Never use excessive amounts of water when cleaning particularly around the control panel.

• Never use scouring pads or abrasive cleaners.
• Always wear protective gloves when cleaning the cooker hood.

Metal Grease Filters

The metal grease filters absorb grease and dust during cooking to help keep the cooker hood clean

inside. The grease filters should be cleaned once a month or more frequently if the hood is used for more

than 3 hours per day.

To remove and replace the metal grease filters

• Remove the metal grease filters one at a time by releasing the catches on the filters; the filters can

now be removed.

• The metal grease filters should be washed, by hand, in mild soapy water or in a dishwasher.

• Allow to dry before replacing.

Active Charcoal Filter

The charcoal filter cannot be cleaned. The filter should be replaced at least every three months or more

frequently if the hood is used for more than three hours per day.

To remove and replace the filter

• Remove the metal grease filters.

• Press against the two retaining clips, which hold the charcoal filter in place and this will allow the filter

to drop down and be removed.

• Clean the surrounding area and metal grease filters as directed above.

• Insert the replacement filter and ensure the two retaining clips are correctly located.

• Replace the metal grease filters.

Extraction tube

.

Check every 6 months that the dirty air is being extracted correctly. Comply 

with local rules and regula

-

tions 

with regard to the extraction of ventilated air.

Lighting

.

If the lamp fails to function check to ensure it is fitted correctly into the holder. If lamp failure has occurred

then it should be replaced with identical replacement.

Do not replace with any other type of lamp and do not fit a lamp with a higher rating.

GB