7
EN
3.
Open the bracket and the filter will
appear. (Refer to Figure 6).
4.
Change a new filter, press the semicircle bracket by one hand to
release the fastener from the filter screen, and remove the filter grid by
the other hand and then change a new one. (Refer to Figure 7)
5.
Reverse the dust box, tear out the mop, release the trailing bar and then
unplug the right and left fasteners on the bottom of the dust box (Refer to Figure 8 and Figure 9). All
parts should be assembled as before
disassembly.
Don’t use the mop and trailing bar on the carpet or uneven ground.
Cleaning of Dust box and Blower:
1.
First dump the dust, and then clean it with
Dust Brush. (Refer to Figure 1)
2.
Pop up the fan motor and then clean the
air inlet/outlet with dust brush. (Refer to
Figure 2 and Figure 3)
3.
Don’t clean the fan motor in water!
4.
Pop up the fan motor, take out the filter,
and then the dust box in water. (Refer to
Figure 4)
5.
Clean the filter by hairdryer or Dust brush.
(Refer to Figure 5 and Figure 6)
6.
After cleaning, you can assemble it firmly as
before the disassembly.
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
