8
EN
Assembly & Disassembly and Cleaning of Fabric Brush, Rubber Brush, Side Brush:
Regularly remove the side brushes, fabric brush and the rubber brush and remove accumulated on
the pins hair. This is the basic maintenance of Cleaner . Failure to do so may result in overload ,
and even burning brush motors.
Assemble & Disassembly of Fabric Brush and Rubber Brush:
1.
Push the locking bar forward and raise the cover.
2.
Take out the fabric brush and rubber brush.
Assembly & Disassembly of Side Brush:
1.
Release the screw in the main shaft of the side brush
before changing the side brush.
2.
Press the side brush against the main shaft and then
fasten the screw.
Cleaning of Sensor and Infrared Transparent Window:
1.
Clean the sensor and infrared transparent window with the cotton swab or soft cloth.
2.
The wall detection sensor is in front of the Cleaner, while the ground detection sensor and infrared
transparent window are at the bottom of the Cleaner. (Refer to the Figure below)
3.
Please keep the transparent window clean so as to make the Robot work better.
