tm2692 Jan-20
24
3.2. Light bulb replacement
To replace light bulb do the following.
1. Turn off the machine and disconnect it from the mains. Wait until the machine
cools down.
2. Unfasten four latches (1) that holds the door (2). Take the door by plastic
handles and pull it out.
3. Light bulb is located in the upper part of the chamber.
4. Remove four bolts (4) that hold protective glass (3).
Fig. 6 Light bulb replacing
5. To demount the lightbulb (5), shift it a bit aside (right or left). Spring-loaded
lamp socket (6) needs to be squeezed a bit to take off the bulb.
THE BULB MIGHT BE HOT! BURN HAZARD!
6. Spare lamp is included in the delivery set. To replace the lamp, take the
spare one from the box, but do not extract from the plastic wrap.
Do not touch the new lightbulb with bare fingers; skin fat can cause bulb
destruction during further operation! If the bulb is greasy, wipe it thoroughly with
soft, clean and dry cloth before putting it in.
7. Take the bulb using the same cloth, and insert one end in the socket (6).
Squeeze the socket a bit and insert the other end of the bulb.
8. Set protective glass (3) back and fix it with four bolts (4). Then put the door
(2) back and fasten the latches.
3.3. Preservation
If the machine is not operated for a long time, it is necessary to perform all
cleaning procedures listed above.
Summary of Contents for ROBOPOP 60
Page 34: ...tm2692 Jan 20 34 Annex F Parts list ...
Page 35: ...tm2692 Jan 20 35 ...
