Message
Displayed
Probable Cause/Event
Corrective/User Action
-
Power supply cable is not plugged properly
into the mains supply.
-
Confirm power supply is plugged into
the main power receptacle.
Check power
(Winter charger)
-
No power to receptacle or main power is
shut off
-
Turn power on to the main receptacle.
-
Check the mains supply using another
appliance
Check wire
-
Poor connection of perimeter wire - twisted
cables, or a screw terminal, insulated with
insulation tape is not a satisfactory splice.
Soil moisture will cause the conductors to
oxidize and after a while result in broken
circuit.
-
Too long perimeter wire
-
Check and repair all loose/poor or
corroded connections.
-
Use only the connectors supplied in the
box. It is waterproof and gives a reliable
electrical connection.
-
The maximum length of wire allowed in
one lope is 500m – if the wire is longer
than 500m, split the area into 2
separated zones.
Close cover
-
The bumper cover is not in its place because
one of the following reasons:
1.The cover has popped out during
operation while Robomow has collided in
obstacle.
2.The bumper cover was not placed properly
by the user in its place.
1. In case of short / slanted obstacles, it
must be protected from the
Robomow using the perimeter wire
around it.
2. Press the bumper cover downwards
and confirm it is clicked well.
W
ire
outside
-
The perimeter wire is too close to the edge
-
The lawn slope is too big
-
Robomow does not succeed to turn in place
at the edge and it causes the mower to slip
out of the area.
-
Too low cutting height for the lawn and grass
conditions.
-
Remove the wire towards the inner side
of the lawn and do not include area with
too big slopes.
-
Fill any holes and pits in the ground.
-
Increase the cutting height
Drive overheat
cooling, wait…
-
The drive motors have been working under a
severe load for too long.
-
There is no need to do anything
Robomow will renew automatically the
operation, as the drive motor will cool
down.
Enter code
-
The theft guard system is activated
-
Enter the correct 4-digit code. ‘
Theft
Guard’
can be deactivated under
‘
Settings’
. Contact your service provider
for assistance in a lost code situation.
Failure: xyz
-
Internal failure
-
Press ‘go’ to confirm the message; if
the message is still displayed, remove
the battery fuse for 10 seconds and
retry to operate the mower. If the
message still displayed, contact your
service dealer.
CAUTION
– Remove battery fuse before
lifting the mower
-
The Robomow has driven onto an
obstacle, raising the front end. Remove
or exclude this object from the mowing
area.
-
The Robomow is being used on a slope
too steep for safe mowing. Exclude this
from the mowing area.
-
High grass is preventing the front wheel
from fully riding on the ground. Raise
the cutting height.
Frnt wheel prob
-
The Front Wheel has left the ground for
more than 8 – 10 seconds.
-
The ground contains large holes or
indentions where the front wheel can
drop into when passing across. Fill
these areas with dirt and level off.
42
