Message
Displayed
Probable Cause/Event
Corrective/User Action
High temperature
waiting…
-
Robomow is charged through the Base
Station and the ambience temperature is out
of range (above 158ºF / 70ºC);
-
Do not do anything, the charging is
stopped and Robomow is waiting for
temperature to change back to the
allowed range; if temperature stays out
of the range for more than 12 hours, the
message is changed to
‘High temp.
Press GO
’.
Insert fuse
for charging
-
Robomow is connected to charging without a
battery fuse
-
Disconnect Robomow from charging,
insert the battery fuse and reconnect to
charging.
Keep charging
if not used
-
Message is displayed every time the power
supply is disconnected.
-
Displayed when the mower isn’t in operation
and not connected to the charging for a long
time.
-
Press any key to change the display
back.
-
Send the mower back to the Base
Station for charging / connect the power
supply or continue in operation.
Key pressed
-
One of the operating panel buttons is
constantly pressed.
-
Press ‘
GO’
to confirm the message and
to continue in operation. The message
is displayed to inform the user about
the problem, but will not prevent the
operation.
Keys locked
-
Child lock feature has been activated
-
Press the
Up
⇑
arrow key and then
press the
‘STOP’
button.
Child lock can be deactivated under the
‘
Settings
’ menu.
-
Mower is searching for the Base Station but
the battery voltage is too low to continue the
searching process.
-
Drive the mower manually using the
remote control or carry it by hand for
charging in the Base Station.
Low battery
-
Robomow has skipped the last start time due
to low battery voltage
-
Confirm there is enough time between
the two adjacent departures so the
battery can be charged prior the
scheduled operation (min 16 hours
between operations)
Low temperature
waiting…
-
Robomow is charged through the Base
Station and the ambience temperature is out
of range (below 32ºF / 0ºC);
-
Do not do anything, the charging is
stopped and Robomow is waiting for
temperature to change back to the
allowed range; if temperature stays out
of the range for more than 12 hours, the
message is changed to ‘
Low temp.
Press GO’
.
Mow overheat
cooling, wait…
-
The mowing motor has been working under
a severe load for too long of a time.
-
There is no need to do anything –
Robomow will renew automatically the
operation, as the mowing motor will
cool down.
No wire signal
-
Base Station / Perimeter Switch is not turned
on or not connected to the zone intended to
mow.
-
The perimeter wire is not connected to the
Base Station / Perimeter Switch
-
The perimeter wire is cut
-
Make sure the Base Station is
connected to the mains supply
-
Disconnect the Base Station power
supply from the mains power and
reconnect after 10 seconds.
-
Check the Perimeter Switch is
connected to the correct zone and is
turned on.
-
Check the connection of the perimeter
wire to the Base Station / Perimeter
Switch.
-
Check for cut in the perimeter wire.
Peg base
then press GO
-
This message is displayed after ‘
Base
position
’ test is completed successfully.
-
Fasten the base in place using the 2
stakes (figure 1.30).
Rain detected
GO to ignore
-
Robomow detects rain upon GO pressing
(received when pressing the GO button)
-
Do not operate Robomow in rainy
weather and wet grass; If you choose to
override, press the ‘
GO
’ button; The
overriding is valid for the current
operation only
43
