11.
Base Station/Perimeter Switch and Perimeter Wire
Robomow cannot operate without a perimeter wire installed and activated through the Base
Station/Perimeter Switch. In the event the Base Station/Perimeter Switch is turned off or
otherwise fails to function, Robomow will stop operating. Likewise, should a break in the
perimeter wire occur Robomow will again stop operation. A break in the perimeter wire prior
to operation will prevent Robomow from operating. It can only operate within the boundary of
the perimeter wire.
12.
Automatic warning alert before operation
When the mower is scheduled to start the automatic operation from the Base Station per a
scheduled time, a warning buzzer and the operating lamp will activate 5 minutes prior to
operation. This is a warning notification to clear and inspect the area.
13.
Over-heat Monitoring Protection
The blade motor and each of the two wheel drive motors are monitored continuously during
operation for any situation that may cause these motors to over-heat. In such event,
Robomow will stop operation of at least that motor and possibly the mower itself and indicate
that the motor is cooling down. While unusual, this may happen when the mower is on grass
that is severely overgrown; the underside of the mower is clogged from poor cleaning
maintenance; the mower has encountered an obstacle that is unable to activate the bumper
sensor preventing it from moving; or a problem landscape area has caused the mower to get
stuck and is preventing it from moving.
WARN
ING!
ill be found at several
o
This warning symbol w
points throughout the pages of this manual.
It is intended to highlight an important safety,
warning or cautionary message.
Please pay particular attention to these
areas and be sure y u fully understand
the message before proceeding
.
8
