41
EN
Display
Message
Probable Cause/Event
Corrective Actions
0016
Low
temperature
-Mower does not depart
automatically from the Base Station
when the ambiance temperature is
lower than 5ºC (41ºF).
-Information – When the temperature
is below 5ºC (41ºF) the grass does
not grow or grows very slowly.
However Manual Depart is enabled.
-No need to do anything.
-Robomow will renew the operation
automatically as soon as the ambiance
temperature will rise above 5ºC (41ºF).
0020
Rain detected
-The operation is delayed as
Robomow detects rain.
-Robomow should resume operation
30 minutes after it stops to detect
the rain.
-No need for action.
-The message is displayed until Robomow will
not detect rain and then will start mowing.
0021
Check mowing
height
-Mowing motor has faced over-
current conditionsfor too long as a
result of high grass or an obstacle
that is stuck or wrapped around the
blade.
-Something is preventing a blade
from rotating freely.
-Severe grass accumulation under
the mowing deck, rope, or similar
object is wrapped around mowing
blade.
-CAUTION – Switch Off the Safety Switch
before checking the blade.
-Inspect the blade for foreign material or debris
preventing rotation.
-Clean out accumulated grass clippings using
a wooden stick.
0022
Check mowing
motor
-Mowing motor has faced over-
current for too long in the Base
Station before starting the operation.
-CAUTION – Switch Off the Safety Switch
before checking the blade.
-Remove the mower from the Base Station.
Inspect the blade for foreign material or debris
preventing rotation.
0023
Check power
-See E4 in the above table
0026
Base problem
-Robomow fails to enter the Base
Station several consecutive times.
-Adjust the Base Station position.
-Clean the contacts with a brush or piece of
cloth.
0027
Start Elsewhere
-Drive wheel motors have been
working under severe load during
automatic or manual operation.
-Check to insure the mower is not stuck,
causing the drive wheels to slip.
-Check the ground around the mower for holes
or indentations. Fill with dirt and level off.
-Check if the drive wheels are free to rotate
and nothing is blocking them.
-Remove the mower away from this particular
location and restart operation.
0028
Cross Outside
-The Perimeter Wire is too close to
the edge.
-The lawn slope is too big.
-Robomow does not succeed to
turn in place at the edge and it
causes the mower to slip out of the
designated area.
-Robomow has slipped out of the
Perimeter Wire lope because of
sloping area or wet grass.
-Remove the wire towards the inner part of the
lawn.
-Do not include this area because of its steep
slopes.
-Fill holes and pits in the ground.
-Increase the cutting height.
0030
Start Inside
-Automatic operation is initiated
while the robot is placed out of the
Perimeter Wire loop.
-Place the mower inside the lawn and renew
the operation.
0031
Stuck in place
-See E1 in the above table
0060
Check mowing
hours (%)
-The mowing hours % value you
have set is too high for your lawn
area.
-Decrease the mowing hours % you have set
for the zone(s) in your lawn.
0061
Decrease
Inactive Time
-See E8 in the above table
