7
Robomow
®
Safety Features
1.
Child Guard / Safety Guard (Level I)
This menu option offers a safety feature to help prevent children or others not familiar with the safe operation
of the mower to operate it freely.
2.
Anti-Theft / Safety Guard (level II)
The anti-theft system provides the user a disabling function that will prevent anyone from using or driving the
Robomow unless they have the valid code to enter. You will be prompted to enter a four-digit code of your
choice to use as your personal security code.
3.
Lift Sensor
There is Hall-Effect Sensor (Magnetic Position Sensor) located in the front side of Robomow. In
case the front of the mower is raised approximately 1-inch from its resting position on the ground
during blade operation, the blade will immediately stop rotating (< 1 second).
4.
Tilt Sensor
There is an optical sensor located in the front side of Robomow. In case the front of the mower is lifted up
towards a vertically position, the blade will stop immediately and Robomow will warn about it and instruct the
user to remove the fuse before lifting Robomow.
5.
Bumper Sensor
The bumper is equipped with Hall Effect sensor activates when the mower strikes a solid, fixed object and
when the bumper cover is open. When the bumper sensor is activated, the mower will stop the rotation of
the blade immediately (<1 second), will stop movement in that direction and reverse itself away from the
obstacle.
6.
Emergency Stop Button
Located on the control panel, red in color. Pressing this button at any time during operation will stop all
mower movement and stop the rotation of the blade immediately (<1 second).
7.
Batteries Fuse
Located below the bumper cover, on the left side of Robomow. Removing the battery fuse will prevent any
operation of the Robomow. It is required to remove the fuse before lifting Robomow and before any
maintenance is done.
8.
Two-Step Operator Presence Control
While in manual mode using the remote control, it requires two independent finger actions in order to engage
the mower blade. Once engaged, the mower blade button must remain depressed to continue blade
operation. Once released, the two-step engagement process must be repeated.
9.
Electronically Controlled Charging System
Robomow is equipped with an on-board charge control system. This allows you to keep the charger
connected at all times, even after the battery is fully charged. The control system will prevent an overcharge
to the battery and keep it fully charged and maintained for the next use.
10.
Sealed Batteries
The batteries that operate the Robomow are completely sealed and will not leak any type of fluids,
regardless of position. In addition, the batteries contain a one-time-use fuse in the event of a short-circuit or
power malfunction.
11.
Perimeter Switch and Perimeter Wire
Robomow cannot operate without a perimeter wire installed and activated through the Perimeter Switch. In
the event the Perimeter Switch is turned off or otherwise fails to function, Robomow will stop operating.
Likewise, should a break in the perimeter wire occur Robomow will again stop operation. A break in the
perimeter wire prior to operation will prevent Robomow from operating. It can only operate within the
boundary of the perimeter wire.
