77
INFORMATION ABOUT THE USE
ENG
6.2. DESCRIPTION OF THE CONTROLS
1)
Emergency stop button:
it is used in case of imminent risk to stop, with a voluntary action, the machine parts which may pose a risk.
For more details, see the paragraph “description of safety devices”.
2)
User interface:
it is used to set or modify the machine operating parameters.
The user interface is equipped with a display and a multi-function selector (7).
For more details, see the paragraph “Description of user interface”.
3)
“Cycle start” button:
it is used to start the wrapping automatic cycle.
4)
“Cycle stop” button
:
it is used to stop the wrapping automatic cycle.
5)
“Reset” button
:
it is used to reset the machine before restarting it after an emergency stop or after a shut-down due to the
disconnection of the power supply.
6)
Emergency override key-operated switch:
it is used to temporarily bypass the carriage emergency.
When the key
is turned to position “
I
” (hold to run), the user interface screen will display the page “emergency
override” and this allows, by pressing the “start” button (
7), to lift only the carriage.
7)
Multi-function selector:
it allows activating and setting machine functions.
Turn the selector (clockwise or counter-clockwise) and release it when the concerned page or function is
displayed. Press to activate the selected function.
8)
Main disconnecting switch: to activate and disable the power supply.
-
Pos. “
O
”: power s
upply off.
-
Pos. “
I
”: power supply on.
9)
Indicator light
(For “FREEZER” and “INOX” versions only).
When the indicator is on, it indicates that the electric control panel is in heating phase.
During this phase, any action on the controls will be ineffective.
Once the electric panel heating phase is complete, the display will indicate that
the “Reset” button (
5) must be pressed.
The heating is automatically enabled and disabled at the temperatures (minimum and maximum)
set by the manufacturer.
Summary of Contents for Masterplat FREEZER
Page 2: ...ENG 2 Page left blank intentionally ...
Page 22: ...ENG SAFETY INFORMATION 22 Masterplat PLUS Masterplat PLUS TP3 Masterplat PLUS LP ...
Page 31: ...31 TECHNICAL INFORMATION ENG Masterplat PLUS Masterplat PLUS TP3 Masterplat PLUS LP ...
Page 91: ...91 INFORMATION ABOUT THE USE ENG R Manual cycle See Manual Cycle ECO cycle See Eco Cycle ...
