ENG
REPLACEMENT INFORMATION
110
9. REPLACEMENT INFORMATION
9.1. RECOMMENDATIONS FOR REPLACING MACHINE PARTS
-
Carry out the interventions with all the safety devices enabled and wear the required PPE.
-
Do NOT carry out interventions that are not described in the manual but contact a Service Centre authorised
by the manufacturer.
-
Do NOT dispose of materials, polluting liquids and the waste generated during the interventions into the
environment but dispose of them according to the standards in force.
Important
Before performing any maintenance operation, activate all safety devices provided and evaluate
whether it is necessary to inform the personnel operating on the machine and the personnel nearby.
In particular, demarcate the neighbouring areas to prevent access to the devices that could, if
activated, cause unexpect
ed hazardous conditions posing a risk for people’s safety and health.
When replacing worn parts, use only original spare parts.
The Manufacturer is not responsible for any damage to property or injuries to people caused by the use
of non-genuine spare parts or which may result from repairs not authorised by the Manufacturer.
When ordering new spare parts, follow the instructions given in the spare parts catalogue.
9.2. FILM CUTTING BLADE REPLACEMENT
1.
Remove the guard by removing the four screws (D) of the support (C).
2.
Remove the blade support (F) by removing the two screws (E).
3.
Loosen the fastening screws (A).
4.
Remove blade (B) and replace it with a new one.
5.
Tighten the screws (A) when finished.
6.
Refit the blade support (F) and the guard.
Caution - warning
Handle with care as the blade is very sharp.
