ENG
INFORMATION ABOUT THE USE
98
6.18.3. WRAPPING CYCLE WITH FEEDER
To select the cycle press the button (C3).
The machine performs a cycle aimed at making it easier for the operator to completely cover the pallet and ensuring
the higher possible level of protection.
The spool carriage rises until reaching the carriage upper end, moves down again by approximately 300 mm and
stops in this position.
If the machine features a presser, it rises from the load.
At this point, the operator, after placing the covering sheet onto the top of the pallet, activates the cycle again by
pressing the “START” button: the presser moves down again.
The carriage rises until reaching the pallet upper end, performs the programmed upper wrapping turns and moves
down to complete the cycle.
In this way, the position of the covering sheet, tightly bound to upward and downward film turns, is the most suitable
for ensuring an optimum protection of the load against external agents (water, dust, etc.).
Rotoplat LP 308-508-708
Rotoplat TP3 308-508-708
