- 55 -
M
N
C
E
D
L
H
G
F
A
English
- 55 -
Chapter 6
ABOUT THE USE
6.7.
“WRAPPING CYCLE” SCREENSHOT
The screenshot displays the controls to program the wrapping cycle.
A) Area
: the name and number of
the recipe are displayed.
C) Push-button
: used to select the
type of wrapping cycle of the
pallet.
At each activation, the push-
button displays the function
enabled with the reference icon.
-
Icon
(C1)
: used to select the
“Single wrapping “ cycle.
-
Icon
(C2)
: used to select the
“Double wrapping” cycle.
-
Icon
(C3)
: used to select the
“Double wrapping cycle with
sheet feeder” .
D) Push-button
: used to select
the stop mode (automatic or
programmed) of the spool carriage
during lifting.
At each activation, the push-
button displays the function
enabled with the reference icon.
-
Icon
(D1)
: used to select
the automatic stop of the
spool carriage (lifting phase)
depending on the height of the
pallet being wrapped .
-
Icon
(D2)
: used to select the programmed stopping of the spool
carriage (lifting phase) depending on the height of the pallet.
By activating this button (altimeter), another button opens next to
the
(E)
button which allows you to set the height of the pallet.
With this function activated, if you wish to delay the wrapping you
must set a height that is greater than that of the product to be
wrapped.
E) Button
: it is used to schedule the delay of the stopping point of
the spool carriage while it is rising (only with automatic stop).
F) Push-button
: used to enable and disable the programming of the
distance from the ground (offset) for wrapping start.
-
Blue coloured background:
Function enabled.
-
Grey coloured background:
Function disabled.
G) Push-button
: used to program the distance from the ground (offset)
for wrapping start.
The push-button is only visible if the function was enabled through
the button
(F)
.
H) Push-button
: used to enable and disable the programming of
reinforcement wrapping.
-
Blue coloured background:
Function enabled.
-
Grey coloured background:
Function disabled.
