SPIROR HP - DR
The parameters of the wrapping cycle
are the following:
B1)
Winding number (variable from 1 to
9).
Allows to set the additional number of
rpm that need to be carried out at the
beginning of the wrapping cycle (top of
product).
B2)
Winding number (variable from 1 to
9).
Allows to set the additional number of
rpm that need to be carried out at the
center of the product.
B3)
Winding number (variable from 1 to
9).
Allows to set the additional number of
rpm to be carried out at the end of the
wrapping (tail of product).
C)
Product wrapping cycles.
‒
"Total" wrapping.
The product is completely spiral wrapped
with a series of extra revolutions on head
and tail.
‒
"Head - tail" wrapping.
the product is only wrapped on head and
tail.
‒
"Complete" wrapping and "central
bands".
The product is completely wrapped in a
spiral, with a series of additional loops at
the head, at the tail and with a series of
reinforcement strappings spaced by a
programmable time.
‒
"Head-tail" and "central belts" wrapping.
The product head and tail are wrapped
with a series of reinforcing bands spaced
by a programmable time.
‒
“Head and additional bands” winding
(Optional).
The head of the product is wrapped and
a series of additional reinforcement
strappings are made (their number and
the distance between them can be set
from the relevant parameters).
‒
"By-pass" cycle.
the product goes through the machine
without being wrapped.
English
68/95
Summary of Contents for SPIROR DR
