RS-Helios-1610 User Manual
44
C.3 Set Up Network
As mentioned in Section 2, the LiDAR has a factory default IP address to be sent to computer.
Therefore, by default, the static IP address of the computer needs to be set to 192.168.1.102, and
the subnet mask needs to be set to 255.255.255.0. In addition, you need to make sure that the
RSView is not blocked by firewalls or third-party security software.
C.4 Visualize Streaming Sensor Data
1. Connect LiDAR to power and connect to computer by network cable.
2. Right Click to start the RSView application with
Run As Administrator.
3. Click on
File > Open
and select
Sensor Stream
(Figure C-1).
Figure C-1 RSView Open Sensor Stream
4. The Sensor Configuration dialog will appear. In “Type of Lidar”, Chose RSHelios. In “Intensity”,
chose Mode3. Then click
OK
, as shown in Figure C-2:
Figure C-2 Select RSHelios Parameter Configuration File
5. RSView begins displaying the sensor data stream (Figure C-3). The stream can be paused by
pressing the
Play
button, pressing again, the stream resumes.
