RS-Helios-1610 User Manual
48
Figure C-13 RSView List Selected Points Tool
10. Any selected points can be saved via
Spreadsheet>Show only selected elements>Output
CSV data.
C.7 Set RSView Data Port
The default MSOP port number of RS-Helios is 6699, and the default DIFOP port number is 7788.
If these two port numbers of RS-Helios are modified in the means described in Section C.7 in
other ways, you will need to reset the Data Port that RSView acquires data to the modified port
number, otherwise there will be no data display. If you don’t know the MSOP port number and
DIFOP port number of your RS-Helios, you can connect it to the computer and use Wireshark to
capture LiDAR packets to view the Data Port information.
Click
Tools> Sensor Network Configuration
, enter the modified RS-Helios MSOP Port and DIFOP
Port, and click
Set Data Port
.
Figure C-14 Sensor Network Configuration
