Robot Coupe Blixer 3, User Manual

9

18/09/2017

The motor seal can be easily replaced without 
having to remove the motor, so we strongly advise 
you to ensure that it is in good condition.

• LOCKING WASHER ASSEMBLY

The locking washer assembly is located on the 
lower inside of the bowl and holds the bowl 
in place. If it becomes worn, it needs to be 
replaced.

• SCRAPER ARM

The scraper arm is equipped with rubber pieces 
which are wearing parts. They should be replaced 
occasionally to always ensure an optimum 
efficiency of the scraper arm. 
These pieces are easy to dismantle and to 
reassemble.

    MAINTENANCE

• BLADE

The quality of the cut depends mainly on the 
sharpness of your blades and the degree of wear. 
The blades are actually wearing parts, which 
should be replaced occasionally to ensure consistent 
quality in the final product.

• MOTOR SEAL

The motor seal around the motor shaft should be 
lubricated regularly using a food safe lubricant.
In order to keep the motor completely watertight, 
it is advisable to check the motor seal regularly for 
wear and tear and replace it if necessary.

Rubber piece to  

scrape the bowl

Rubber pieces to 

scrape the lid.

Drawing 1

Drawing 2

Drawing 3

Check that your detergent is suitable for 
cleaning plastic parts. Some washing agents 
are too alkaline (e.g. high levels of caustic 
soda or ammonia) and totally incompatible 
with certain types of plastic, causing them to 
deteriorate rapidly.

I M P O R T A N T

Then wash the blade in the dishwasher. 
After washing, always wipe the blade well in order 

to prevent oxidation.

• SCRAPER ARM

To clean the scraper arm, dismantle it as follows. 
Hold the scraper arm in one hand and the hub in 
the other hand (drawing1). Press the two pieces 
one on the other, and turn the handle of 45° 
anticlockwise (drawing 2). Then it is possible to pull 
out the two pieces (the scraper arm and the handle) 
from the lid and clean them (drawing 3).