7
ENGLISH
ASSEMBLY J80 Ultra
Motor unit
Bowl
Spout
Flange
Basket
Pulp container
Lid
Drip tray
Feed tube
Ejector
Grating disc
Handles
7
6
8
5
4
3
2
1
7
5
4
2
3
1
You can also refer to the label (below) stuck to the
lid.
Make sure that the pin
on the motor shaft is
correctly lined up with
the
corresponding
notch in the basket
hub.
IMPORTANT
Sieve
Safety arm
1
3
8
6
3)
Fit the flange onto
the rim of the bowl.
TThe ribs of the flange
should be lined up with
the flat panel of the
bowl. Check that the
flange is correctly
fitted.
5
5)
Line the lid up with
the notches in the
flange
1)
Position the motor
unit so that the On/Off
buttons are facing you.
2)
Place the bowl on
top of the motor unit.
4
4)
Lower the basket
into place, holding it
by its handles.
Rotate it until it slots
into place.
2
