Robot Coupe R 3 Manual Download

Page: 9 / 26

Eng

• WORKING HEIGHT

We recommend that you position the machine on a
stable worktop so that the upper edge of the large
feed hopper is at a height of between 1.20 m and
1.30 m.

• NOISE LEVEL

The equivalent continuous sound level when the
machine is operating on no-load is less than 70
db(A).

• ELECTRICAL DATA

Single phase machine R 3

CLEANING

• MOTOR BASE

Never immerse the motor base in water. Clean
using a damp cloth or sponge.

• BOWL CUTTER

After removing the lid, remove the bowl from
the motor base by rotating it to the left. Pull up to
disengage, leaving the blade in the bowl in order to
prevent any spillage when working with liquids.
If the food has a solid consistency, remove the blade
and empty the bowl.
Replace the bowl, place the blade back on the shaft
and switch on the machine in order to remove any
mixture which may have stuck to the blade.
If you wish, you can rinse the bowl by filling it with
hot water and switching on for a few minutes.

• BLADE

After cleaning the blade, always dry the blades well
to prevent rusting.

• DIMENSIONS (in mm)

As a precaution, always unplug your appliance
before cleaning it (risk of electrocution).

W A R N I N G

Check that your detergent is suitable for
cleaning plastic parts. Some washing agents
are too alkaline (e.g. high levels of caustic
soda or ammonia) and totally incompatible
with certain types of plastic, causing them to
deteriorate rapidly.

I M P O R T A N T

R 3

400

320

210

200

R 4

R 4 V.V

460

304

226

235

MAINTENANCE

• BLADE

The quality of the cut depends mainly on the sharp-
ness of your blades and the degree of wear.
The blade is, in effect, a wearing part, and has to
be replaced every so often in order to ensure
consistently good results.

• MOTOR SEAL

The motor seal on the shaft should be lubricated
regularly using a food safe lubricant.
In order to keep the motor completely watertight, it
is advisable to check the motor seal regularly for
wear and tear and replace if necessary.

• BOWL LOCATING PLATES

If these plates wear out, the bowl will no longer be
securely attached to the motor base.
This makes it awkward to use since the bowl can
come loose during processing.
There is no risk to the user however, because the
safety system will automatically stop the machine.
It is advisable therefore to change these plates in
order to ensure maximum ease of use.

TECHNICAL
SPECIFICATIONS

• WEIGHT

Net

Gross

R 3

13 kg

14 kg

R 4

15 kg

17 kg

R 4 V.V.

15 kg