If you have chosen the
dicing combination :
i.e. a grid and a specific
slicing disc.
Only the specific 8 mm
and 10 mm discs can be
fitted with a dicing grid.
Position the dicing grid
in the vegetable prepa-
ration bowl.
7
5) Push the on button, and with a firm grip on the
fruit, press it down onto the cone. When the juice
has been exctracted, press the off button.
• VEGETABLE PREPARATION ATTACHMENT
The vegetable preparation attachment consists of
two detachable parts : the continuous feed attach-
ment and the continuous feed lead.
1) With the motor base
facing you, fit the conti-
nuous feed attachment
onto the motor base; the
exit chute should be on
your right. When first
placed onto the motor
base, the attachment will
be off-center to the left.
2) Turn the attachment
back to the right until it
comes to a stop, and is
aligned with the top of
the motor base.
3) Place the white
discharge plate onto the
motor shaft. It should fall
into place just off the
bottom of the continuous
feed attachment.
4) Place the cutting plate
of your choice onto the
discharge plate. It may
be necessary to rotate
the plate until it drops
fully onto the discharge
plate.
• INSTALLING THE DICING GRID:
The grid must be positioned according to the
feeding hopper used.
Failure to do so, can lead
to jamming and motor damage.
• Position 1 :
Using the
large hopper.
In this case, the
dicing grid should be
positioned so that its
blades are vertically
aligned with the
hopper. (You must be
able to see the grid
blades when looking
into the hopper.)
Next fit the appropriate
slicing disc and screw the
slicer on the motor shaft
with the butterfly nut.
INSTALLING THE FRENCH FRIES GRID :
Specially designed slicing
plates and matching grids
have been developed for
making French fries. Two
sizes are available: 8x8
and 10x10.
With the discharge plate in
place on the motor shaft,
place the French fry grid
into the continuous feed
attachment with the vertical
blades aligned toward the
discharge chute.
If the grid is not in the correct
position, jamming and motor damage may occur.
• Position 2 :
Using the
cylindrical hopper.
In this case, the grid
must be positioned so
that the blades are
vertically aligned with
the tube. (You must be
able to see the grid
blades when looking
into the tube).
