Robot Coupe R 402, User Manual

3) Engage the blade on 

the motor shaft and lower 

it right to the bottom of the 

bowl.

Make sure that it is correctly 

positioned, by rotating it in 

the bowl.

4) Place the lid on the bowl 

and rotate to the right until 

it clicks.

The device is now ready for use. The green light 

should therefore be illuminated.

• VEGETaBLE PrEParaTION aTTaCHmENT

The vegetable preparation attachment consists of 

two detachable parts: the stainless steel vegetable 

preparation bowl and the lid.
1) With the motor base 

facing you, fit the stainless 

steel bowl onto the motor 

base; the ejection chute 

should be on your right.

2) Turn the bowl to the 

right until the motor base 

connectors are securely 

positioned in their sockets.

22

r 402

Red switch 

=  

Off switch

Green switch 

= 

 On switch

Black switch 

=  

Pulse control

Speed selector 

single phase r 402

50 Hz : 500 or 1,500 rpm.
60 Hz : 600 or 1,800 rpm.
Speed selector 

Three phase r 402

50 Hz : 750 or 1,500 rpm.
60 Hz : 900 or 1,800 rpm.

r 402 V.V. :

  Speed variation for 

cutter bowl

 from  

300 to 3,500 rpm.

 for 

vegetable preparation

 from  

300 to 1,000 rpm.

    assEmBLy

•  CuTTEr BOWL aTTaCHmENT

1) With the motor base 
facing you, make sure 
that the bowl is straight in 
relation to the motor shaft, 
with the magnetic bar 
moved slightly to the left.

2) Turn the bowl to the 
right until the motor base 
connectors are securely 
positioned in their soc kets. 
The handle is now in front 
of you.

3) Slot the grey plastic 

ejector disc onto the motor 

shaft and check that it is 

properly positioned at the 

bottom of the bowl. 

4) Choice of disc:
a) If you have opted for a 

slicing, grating or julienne 

disc: 

Position the disc on the sling 

plate.

Only for the r 402 / r 402 V.V. models:

b)

 If you have chosen the 

dicing equipment: 

i.e. a 

grid and slicing disc.

you must only use the 

8-mm, 10-mm or 12-mm 

aluminium slicing discs with 

the dicing grids.

Make sure the dicing grid is correctly positioned in 
the veg prep bowl (see page 23).  
Check that the notch on the edge of the dicing grid 
is correctly positioned over the tab on the bowl (see 
marking on grid).