R302 Operation Manual
7
Sharpening the “S” blade
The “S” blade will require sharpening on a periodic basis depending on use. The use of a
dull blade will sometimes give unsatisfactory results. A honing stone is provided with
each machine for this purpose. Follow the directions shown to sharpen the blade, or have
the blades sharpened professionally if you prefer.
1.
Put on your cut-resistant gloves
2. Use the robot Coupe stone or any good
sharpening stone.
3. Hold or clamp the blade flat on the edge or
corner of a sturdy table.
4. With the other hand hold the stone at a 30
degree angle against the top bevel of one
blade.
5. Pull the stone into the blade edge moving
from hub to tip, several strokes, until the
blade is sharp.
6. Turn the blade over and rub the stone flat
against the underside of the blade to
remove the feather edge formed at step 5.
7. Repeat the procedure for the other blade.
8. Wash the blade before use.
Summary of Contents for R302
Page 2: ...R302 Operation Manual 2...
Page 16: ......
