Robot Coupe Robot Cook, Manual

22

- Read a programme:

Once the programme has been chosen using the key

, press on the step button 

 to view all the steps 

using the rotary dial.
You have the possibility of registering 

9 programmes

on your Robot Cook

®

.

3 recipes

 are already pre-programmed, (see page 

23):

Programme 1

: Béchamel

Programme 2

: Custard 

Programme 3

: Confectioner’s custard

After each step of the programme, a bell will ring to 
indicate that the programme is moving onto the next 
step.

- Create or modify a programme:

By pressing once on the Programme Function 

you then obtain the desired programme by using 
the rotary dial. It allows you to choose from the 
programmes 1 - 9. 
For each step of the programme 

, you enter the 

following parameters:

Heat power and Temperature
Speed
Timer

To create or modify a step, choose the desired step 
by pressing the switch for a few seconds 

, which 

will allow you to enter your parameters. 
After entering your parameters, confirm them by 
pressing the step switch

 again so as register 

them.

- Delete a step:

Go to the step to be deleted, press the step switch 

for a few seconds and then press the red stop 

switch   to delete the step.

The active step has now been replaced by the next 
step.
When all steps have been deleted, the programme 
is deactivated.

The word 

End

 is displayed at the last step. During 

operations, the programme will stop at this point.