Here are feature comparisons between the
Bus-Scan
®
CR2
and the CRS CR2 A/B:
Function
Bus-Scan
®
CR2
CRS CR2 A/
B
Ignition
ON
(12V) Prepares the system for operation.
YES
YES
Arming Signal (12V) Arms the system
OR
...
YES
YES
System will automatically
ARM
after 10 minutes w/door(s) closed.
YES
YES
System has 2 door-sensing inputs: One for +12V / One for 0V (Gnd)
YES
YES
If either the White or Blk/Gry Wire is Grounded (0V), the system will
DISARM
, and the interior lights will flash twice to confirm.
YES
YES
If Exit Courtesy Lights are on, they can be interrupted by turning
the Ignition
ON
, so that the system is immediately ready for
operation.
YES
NO
If the system has been
ARMED
, then the Ignition is turned off, a
reminder tone will sound, indicating that the vehicle must be
checked & disarmed. Also, the dome lights will be activated.
YES
YES
Ignition must be in the
OFF
position to disarm system.
YES
YES
If any door is opened during the
REMINDER
state, the horn will
ALARM
— ½ second on / ½ second off intervals until system is
disarmed.
YES
YES
Ignored Horn Fail-safe operation: An ignored Horn alarm will cease
sounding after 5 minutes, to save battery power and horn function.
YES
NO
If the system is in an
ALARM
state, the only way to stop the alarm
is to recycle the ignition and start the
DISARM/INSPECTION
sequence over. The system will not permit an exit without alarm
until the proper
DISARM SEQUENCE
has been performed.
YES
YES
Upon
DISARM
, the interior lights will remain
ON
for a period of 60
seconds, for help in exiting the vehicle (Exit Courtesy Lights).
YES
YES
Entry Courtesy Lights will be activated for 60 seconds upon first
entry (door open, if closed / door closed, if open). Activating
Ignition will cancel the lights.
YES
NO
If Ignition is
ON
and a door is opened, Passenger Courtesy Lights
will be activated to help guide passengers on/off the vehicle. The
lights will be immediately turned
OFF
upon door closing.
YES
NO
The Warning Beeper is built-in, so no additional wiring is required.
YES
NO
Dual-row, 6-position Interface Connector for Power & Signals
YES
YES
Single-row 2-position Interface Connector for Remote LED
YES
YES
NOTE: We have been told that the main connector in the CRS CR2 A/B was too accessible, and
was being disconnected by some drivers. We have purposely recessed the connector slightly, to
make that less likely. Please let us know if that helps.
More features have been created for the
Bus-Scan
®
CR2. See the next page for
details.
