New CR2 Features
3-Position DIP Switch on Back of Unit
1. Timed Auto-arming
(field-trip mode). In addition to arming the Bus-Scan
CR2
by an input signal (8-way flashers, stop sign, etc.), you can choose to have the
system automatically arm after the ignition has been on for 10 minutes, with both
doors closed. Enable by sliding
Switch 1
of the 3-position DIP switch to the 'ON'
position.
2. Timed Alarm Mode
Adds a timeout alarm to the usual “Door Opened Without
Disarming” mode. Sliding
Switch 2
to the 'ON' position enforces a time limit of 60
seconds for the driver to press the “Disarm” button. Therefore, the system must
be disarmed before opening a door AND within 60 seconds.
3. Diagnostic Mode
This is used for factory testing, but can be used during
installation, to speed up the process. There are many timed functions in the
CR2
,
including auto-arming, light delays, etc. Sliding
Switch 3
to the 'ON' position will
“speed up the clock” to move through those delays very quickly—so that you can
confirm that everything is working properly. For example, the usual Auto-arm of
10 minutes occurs in only 10 seconds. If you use this special Diagnostic Mode,
make sure to return
Switch 3
to the 'OFF' position when you are finished.
Otherwise, the system will not function properly.
