4
Botster™ Robot Kit Part Names (Quantity each in parentheses):
1.)
Chassis Sides (2)
2.)
Upper Deck (1)
3.)
Middle Deck (1)
4.)
Lower Deck (1)
5.)
Front Vertical Deck (1)
6.)
Upper Rear Vertical Deck (1)
7.)
Lower Rear Vertical Deck (1) - Battery Door
8.)
Colored Trim Pieces (4)
9.)
Wheel assemblies – Wheels, Encoder disk, Hubs (2)
10.)
Servos – Hitec HS-322HD (2)
11.)
Traction Bands (4) - two extra
12.)
Hamamatsu Wheel Encoder Modules (2)
13.)
Rear Steel Ball Caster & Mount (1)
14.)
Screw Pack – (1)
15.)
Sharp™ GP2D120 infrared sensor mount blocks (2)
16.)
Front infrared sensor aluminum hex standoffs (2)
17.)
Generic or CMUcam2 Turret and servos (Optional) (1)
18.)
Wheel encoder spacer tubing material
Assembling the Botster™ kit:
1.
Start by trimming the small ribs protruding just above the surface of the servo mount
tab with a razor blade or xacto knife as shown. This will allow the servo to mount
flush with the inside of the chassis side plates. Repeat for both mounting tabs.
Caution!!! Be very careful on this step and do not cut yourself! This should be
performed by an adult!
©2004-2005 Summerour Robotics Corporation – Botster™ Assembly Manual Version 1.4 – 05/15/2005.
Botster™ and Botster Brand™ are Trademarks of Summerour Robotics Corporation 2004-2005.
