26
ROBOVENT • FLEXPRO HI-VACUUM SERIES OWNER’S MANUAL
HVE-950-80-2-CAB
HEX BOLT METRIC
PLAIN WASHER
BONDED SEALING WASHER
1/2" GASKET
M10 RIVNUT
HDH-950-80-2
SECTION 500
Installation
FIGURE 13
FIGURE 12
Process for Locating
Inspect packaging and machine for missing parts or
shipping damage as described in the
“Receiving &
Inspection”
section.
Use the following steps to unpack and locate:
1. Remove packing material and crating from sides.
2. Use a crane attached to lifting points to remove
from pallet.
3. Set machine in place with forklift or crane. Connect
to process(es) with high-vacuum ducting.
4. Adjust airflow to ensure effective fume capture.
Refer to operating instructions.
Setting the Unit in Place
The first step is to set the hopper in the designated
area. Floor will need to be concrete (at least 4" thick)
and fairly level. Bolt hopper to the concrete using
concrete anchors (provided in install hardware kit).
Make sure hopper is level and use shims as necessary.
Set unit onto top of hopper using crane or forklift
(Figure 12). Open the filter door and remove filter to
provide access to all bolt areas. Using provided bolts,
wasters and sealing washers bolt cabinet to hopper
(Figure 13 and 14) through the filter door. Hook-up
compressed air and electrical and mount HMI and your
HVE H-Vac machine is ready to go!
FIGURE 14
A
Summary of Contents for FlexPro Hi-Vacuum Series
