ROBOVENT • FLEXPRO HI-VACUUM SERIES OWNER’S MANUAL
51
SECTION 900
Maintenance
FIGURE 29
FIGURE 30
10. Slide new filters into track and clamp down. Make
sure filters are fully toward the rear by pushing
on the top pans; the first filter should be behind
the tabs in front of each row, marked with a label.
Push levers forward to clamp and seal. Note –
Improperly seated filters will cause dust to bypass
into the clean air stream. (see Figure 29).
11. Visually inspect filter door gasket. Replace any
loose or damaged gasket.
12. Close filter door.
13. Turn power to machine back on.
14. Turn system on and start blower.
15. Record new filter differential pressure. The blower
will need some time to ramp up to speed. Once
CFM and pressure have stabilized, the value can
be recorded.
16. Reset the service hours on the control screen.
(see Figure 30). You will need to login to reset.
To login:
User Name: SERVICE
Password: 4703430
a. Press the System icon, then on the System
page, press the arrow to the right of Login.
(see Figure 31).
b. Press Name: enter user name, all caps, to ensure
all caps you should see a green bar over the Cap
button on left, third button down.
c. After entering the User Name:
SERVICE
, press
enter. (see Figure 32).
FIGURE 32
FIGURE 31
Summary of Contents for FlexPro Hi-Vacuum Series
