ProCube Owner's Manual & Operating Instructions
E2-20171010
©2017 ROBOVENT PRODUCT GROUP, INC.
10
Unpacking & Locating
Follow workplace safety guidelines when handling and unpacking this
machine. Gloves, safety glasses and safety footwear are recommended.
Set aside a 3 m ( 9 ft) work area to allow adequate space for shipping
material and lifting from pallet. Consider cordoning off to prevent traffic
from entering the area.
ENVIRONMENTAL REQUIREMENTS & CONSTRAINTS
This machine is designed to operate in an environment with temperature
10 – 50° C (50 – 120° F) and relative humidity 40-70% (non-condensing).
The ProCube machine is designed for use indoors. Floor surface must be
hard, flat, level, and capable of supporting 1.2 kg/cm2 (17.6 psi) in order
for the unit to remain safely stable. Atmosphere must be mostly free from
contaminants such as dust, oil mist, water and airborne chemical solvents.
If outdoor use is required, the machine must be sheltered from wind, blown
dust and precipitation. Storage must be indoors to prevent condensation in
control panel and motor areas.
Explosive Atmospheres
The machine is neither certified nor designed for use in explosive
atmospheres, potentially explosive atmospheres or for collecting explo-
sive dusts. The user is therefore strictly prohibited from using it in such
applications and conditions. Do not attempt to modify this machine for
the purposes of use in any explosive environment.
Lighting
The machine’s work area must be illuminated so that the control panel,
power cord connection and gauges are clearly visible without the need for
additional local lighting.
When servicing, additional temporary lighting may be needed by mainte-
nance personnel.
Vibration
This machine has been assessed and determined, that in normal design
use parameters, this machine offers no appreciable vibration hazards and
as such, does not require any remedial or secondary action to reduce
vibration.
Noise
The machine is designed in such a way as to offer reduced acoustic sound
pressure levels. The machine noise level has been measured and does not
exceed 68 dB(A).
PROCESS FOR LOCATING
Inspect packaging and machine for missing parts or shipping damage as
described in the “Receiving & Inspection” section.
Use the following steps to unpack and locate:
1. Remove packing material and crating from sides.
2. Use a crane attached to lifting points to remove from pallet.
3. Roll the machine to designated area. Connect to process with 50mm.
flexible hose.
4. Adjust airflow to ensure effective fume capture. Refer to operating
instructions.
