Section END USER
Ed. 04/2012
31
Figure 11 –
The S61 electronic circuit board. The Display, Encoder and CAN-BUS Port
Programming, control and monitoring of the ACF are done through the display and the
circuit board encoder. The CAN BUS port allows one or more ACF’s to be connected to a
Direct Digital Controller (DDC). To connect a DDC to the ACF, go to the “USE OF A
DIRECT DIGITAL CONTROLLER (DDC)” section on page 60.
S61 menu description
The parameters and settings of the ACF are separated into menus on the electrical circuit
board:
MENU
MENU DESCRIPTION
ON THE
DISPLAY
Menu 0
DISPLAY OF DATA (TEMPERATURE, VOLTAGE, PUMP SPEED)
Menu 1
DISPLAY OF ALL THE ACF PARAMETERS
Menu 2
FLAME CONTROL UNIT RESET AND ERROR RESET
Menu 3
END USER SETTINGS (THERMOSTAT SETTING, SET POINT, T. DIFFERENTIAL)
Menu 4
INSTALLER SETTINGS
Menu 5
SERVICE CENTER SETTINGS
Menu 6
SERVICE CENTER SETTINGS (MACHINE TYPE)
Menu 7
DISPLAY OF DIGITAL INPUTS
Menu 8
(MENU NOT USED)
Table 17 –
S61 menus
KEY
A
4 digit DISPLAY for the visualization of the data and operational codes
B
KNOB (encoder) for navigating and selecting of operational data
C
CAN PORT for the connection of the CAN-BUS network cable
B
A
C
Summary of Contents for GA ACF60-00
