OPERATION AND INSTALLATION
RCI-4100 SYSTEM
MAN-1111 Rev H
©Copyright 2015 LSI-Robway Pty Ltd
Page 13
2. Installation
This section contains general information regarding installation of the RCI-4100IS Rated Capacity
Indicator and its sub-systems in a hazardous area environment.
WARNING: ALL EQUIPMENT INSTALLED IN AN EXPLOSIVE ATMOSPHERE MUST
COMPLY WITH LOCAL GOVERNING STANDARDS. THIS INCLUDES, BUT
IS NOT LIMITED TO, ELECTRONIC COMPONENTS, CABLING, JUNCTION
BOXES, CONDUIT AND SENSORS, ETC.
IT IS THE INSTALLER’S RESPONSIBILITY TO ENSURE LOCAL
STANDARDS AND REGULATIONS ARE COMPLIED WITH.
FAILURE TO COMPLY CAN RESULT IN A HAZARDOUS CONDITION WHICH
MAY RESULT IN INJURY OR DEATH.
IT IS NOT POSSIBLE TO COVER ALL HAZARDOUS AREA INSTALLATION
STANDARDS IN ONE DOCUMENT. INFORMATION CONTAINED HEREIN
MUST BE CONSIDERED ADVISORY ONLY.
2.1. Setting up the Crane
CAUTION:
PRIOR TO PERFORMING ANY INSTALLATION A CERTIFIED OPERATOR
MUST LOWER THE CRANE BOOM TO A SAFE AND CONVENIENT
POSITION.
2.2. Power Supply
The RCI-4100 can be powered by a 10.5 VDC to 36 VDC supply.
The selected power supply may be permanently connected, however for convenience it should be
made via an ON/OFF switch or relay. If the Control Unit is located within a hazardous area, the power
MUST be supplied via steel wire armoured cable in accordance with local installation standards.
2.3. Installing Boom Components
This section describes the installation of all the types of tension based systems and sensors supplied
by LSI-Robway.
NOTE: Refer to the General Arrangement and Wiring drawings in
Error! Reference source not
found.
to determine which components are applicable to the system supplied.
Summary of Contents for RCI-4100
