EN
04
Instructions
After setting up, follow the instructions below to operate the system.
1. Check to make sure that that battery is fully charged and installed correctly.
2.Toggle the switch to the [ON] position. When active the R.LED will be lit.
3. Connect the receiver to power.
Follow the steps below to turn on the transmitter:
For safety always power on the transmitter before the receiver.
1、Power On
Note
Make sure that the throttle is at its lowest position and the switches are set to their up position.
Not
e Operate with caution in order to avoid damage or injury.
Getting Started
Danger
Do not expose to excessive heat or liquids.
Danger
Do not open, disassemble, or attempt to repair the batter
y.
Dange
r
Do not crush/puncture the batter
y, or short the external contacts.
Danger
Do not use the battery if damaged.
Danger
Do not drop the battery or expose to strong shocks or vibrations.
Danger
Always store the battery in a cool, dry place.
Danger
Only use specified battery (X4
AA batteries).
Before operation, install the battery and connect the system as instructed below.
Transmitter Battery Installation
1.Open the battery compartment cover.
2.Inse
r
t 4 f
ull
y-
charged AA batteries into the compartment. Make sure that the battery makes good contact
with the battery compartment's contacts.
3. Replace battery compartment cover.
Battery Type: AA
Battery Installation:
Low battery alarm: When the battery is lower than 4.2
v
, the G.LED on the panel will flash slowl
y.
Summary of Contents for 1:10 Mashigan
