Roca BROADWAY FAMILY, Installation Instructions Manual

4

1. RECEIVING THE EQUIPMENT

The spa should reach its destination in its original packaging. Medidas 

de embalaje son: 1920/1920/1310 mm. Once the packaging has been 

removed, check the spa fully before it is installed and report any anomaly.

Do not lift the spa using the filter equipment or the pipes. 

Do not stand the spa on its edge. Always stand it on its legs.

During the installation, check that the interior of the spa is protected 

by the covering included with the equipment.

The electrical installation and pipe connections must be carried out 

by authorised installers.

2. PREPARING THE PLACE FOR THE INSTALLATION

The Broadway Family SPA can function indoors and outdoors. It must 

be installed on a firm base to prevent it from sinking.

When choosing the location for the spa, a series of requirements must 

be taken into account:

- If you have decided to install the spa indoors, bear in mind the 

thoroughfares required for transporting it to its final location.

- Proper electrical supply and ensured efficiency of the electrical 

connection in respect of the equipment - for standard equipment the 

rated power consumption is ab 7,2 kW, 230V AC 50 Hz (3x6 mm

2

) with 

regard to the safety of the users, in all cases the supply cable must be 

protected by means of a differential-current switch with the standard 

rated switch off current of 30 mA),

- An earth connection compliant with current legislation is essential.

- Access to interior components through the side panels for post-

installation maintenance.

- You must also bear in mind how you are going to fill and empty the 

spa. The floor must be level.

- There must be adequate ventilation in closed interior locations.

- You must bear in mind the materials used on the wall and ceilings, 

since the humidity generated by the spa requires steam-resistant 

materials.

- Due to unavoidable splashing, the floor must be highly-resistant to 

water, such as tiles or plastic coverings. If carpets are used, they must 

be treated to avoid bacteria from damp. Use special sailing carpets or 

rugs. Parquet or wooden floors are not advisable unless they have been 

duly treated for this kind of use, such as wood for gardens or outdoor 

buildings. In any case, make sure that the floor has a gradient of 2% 

towards a drain installed in the room.

3. POSITIONING THE SPA

-When installing the spa in a corner or next to a side wall, remember 

to leave 0.5 metres or connection or installation work or fit trap doors 

with a minimum size of 1700x700 mm for accessing all the sides for 

post-installation maintenance. 

The floor should be very well levelled. Localisation of SPA should 

ensure access to mechanical (devices below the SPA rim (near control 

panel side). All the bath legs should be on a solid and hard surface. The 

total weight of the bath with water and four people is about 1900 kg. 

- This spa cannot be embedded. Do not obstruct access to the side 

panels. 

SECTION 1 + GEYSER

SECTION 2

SECTION 3

SECTION 4

SECTION 5

SECTION 6

CASCADE

4

3

2

6

5

A

A

A

A

A

A

D

D

D

E

I

I

F

K

H

G

J

B

B

B

B

C

C

C

1

A
B

C

D
E
F

G

I

J

K

- fixed mini jets

- fixed mini jets

- large fixed jets

- large whirlpool jets

- large fixed jet

- large fixed jets

whirlpool jet

large fixed pulsating jets

large whirlpool jet

fixed mini ozone jet

-

-

-

-

B

B

CASCADE

STANDARD

SET HEAT