4
5
3. ASSEMBLING THE 4 SUPPORTS OF THE
FIRST PANEL
Ensuring you do not alter the level, remove the upper locknuts (A)
and the flat washer on the rods that form part of the tub legs (B).
Then place the supplied serrated washer and screw the nut back
on, leaving a space between the levelling crosspiece of the legs and
the serrated washer with the nut, so that the panel support units (C)
can be later fitted (see figure 4, close-up of the central unit).
3.1. CENTRAL SUPPORT UNITS.
Following figures 1, 4 and 5a, fit the unit placing the horizontal
support swivel (C) on the threaded rod of the leg (M10) between
the serrated washer (added previously) and nut (A) and the levelling
crosspiece (B) (fig. 4 Central unit close-up).
Important!
Before directly fitting the swivel piece (C) to the (M10)
threaded rod, fit the upper end of the unit (figure 1), adjusting the
threaded rod (G) so that it is tight against the inside edge of the
tub, together with the upper support and its support plate (F). This
can be achieved easily by turning the rod (G). Tighten the nuts (H)
and the nut (A). Adjust the lower plate (P) until it is firmly set on the
floor. Ensure at all times not to lift the tub when tightening the nuts
and that the rod (G) is vertical to the floor.
l
Important!
The right support must be turned towards the right
and the left support to the left, in such a way that the
plates with the Velcro are parallel to the lower curve
of the panel for support (see photos ll, III and lV).
lI
G
G
Plate with Velcro T
to the right of rod G
Plate with Velcro T
to the left of rod G
ll
6
l
b
A
Serrated
washer
Plate
with Velcro
l
G
H
B
A
C
M10 threaded
rod
Lower
Support
P
l
b
W
