Once the fittings are at the correct angle, place the stop (W) as
shown in photo V and Ib. Put the long part of the stop through the
hole in the crosspiece (B) and, with the short end of the stop, fasten
the edge of the horizontal support (C). Fasten the nut below the
crosspiece to avoid the horizontal support from turning.
The bottom plate will be at approximately 15-20 mm inwards from
the vertical plane of the bathtub edge.
Adjust the height of the plate using the swivel unit of the J support
so that the plate is above the bottom fold of the panel (see photo
V).
3.2. OUTER SUPPORT UNITS
Following figures 2, 4 and 5 b, fit the unit by introducing the swivel
unit of the horizontal support (D) on the threaded M10 rod of the
leveling crosspiece, fastening it with two serrated washers (included
with the nuts and bolts) and two nuts (E) (photos VI and VIb).
Between 15-20 mm approx.
CENTRAL SUPPORT
G
E
D
H
E
M10 threaded
rod
V
Vl
The spring is flush
with the edge of the bathtub
V
Vl
8
Inclination of
the plug so that
it is parallel to
the panel
W
B
