ROCK
-
SLIDE ENGINEERING
7
Shut the doors on the vehicle. Steps should retract. If they do not
retract, magnets are mis
-
aligned just barely.
Troubleshooting
: Working on one side of the jeep, unplug the rear
sensor but leave the front door shut. If step retracts after two sec-
onds, front door is aligned. If the step stays down open the door,
shift magnet slightly then shut the door. Wait two seconds to see if it
retracts. Repeat until step shuts while door is shut. Mark the location
with a sharpie so if the magnet shifts you can put it back. Leave the
front door closed. Re
-
connect the rear sensor. Repeat the same
method for testing magnet placement. Mark with a sharpie, or apply
a dab of superglue.
Recheck all wires to make sure they are completely secure and free
from coming into contact with any moving parts to prevent system
damage. Tuck all wires back out of heavy traffic on the floor. Secure
loose wires with zip ties. Route the wires underneath the rear seat
towards the back for protection.
Reinstall internal plastic and carpet pieces
Secure wiring harness in the engine bay using zip ties.
Double check bolts are tightened.
Install optional door delete kit. SL
-
DD
-
100
31
32
33
34
35
Figure 7.34.1
Figure 7.34.2
