Rock Solid Metered PDU Manual GS Geiger Group ∙ 181 Sand Creek Rd Ste I-1 ∙ Brentwood ∙ CA ∙ 94513 ∙ USA
4
3.
PDU Functions
The PDU functions for the model RSM1-15AA-08N1 are shown below, the functions for the 20A 1U metered
PDU and the 16 output PDUs are also similar.
1. Circuit breaker (for Metered models this is next to the display): For overload power protection, press
to reset if it is tripped.
2. Power outlet receptacle: Connect to your equipment.
3. Yellow SSL LED Indicator: Light on means web access is protected by SSL.
4. Green DHCP LED Indicator: Light on means PDU gets IP address via DHCP.
5. Green Power Output Indicators (not on the Metered models)
6. Meter: 3 digit meter to display current and IP address.
7. Function Button
•
Press and release quickly to turn off the Warning beeps, if the Warning threshold is crossed.
The Overload beep cannot be cancelled.
•
Press and hold the button, after 2 beeps, the display will show the IP address. The octets of
the current IP address will flash once across the display, the display will then resume
showing the current.
•
Press and hold the button, after 4 beeps, the PDU will switch the method of IP assignment. If
current method is DHCP, then fixed IP will be assumed and vice versa.
•
Press and hold the button, after 6 beeps, the PDU will be reset to factory defaults.
8. Speaker for audible alert:
•
Warning Alert: 1 beep in 1 second when Warning threshold is crossed.
•
Overload Alert: 3 beeps in 1 second when Overload threshold is crossed.
The audible alert will keep beeping until the current goes back 0.5 amps below the threshold value.
The warning alert can be disabled, see instructions on the Function Button above.
9. Ethernet Port: RJ45 port for connecting to the network
Summary of Contents for RSM0-30AM-16N2
Page 12: ......