7
Rocketfish Miracast Video Receiver | RF-WFD301
Installing the wireless video receiver
To install your wireless video receiver:
1
Turn off the TV.
2
Insert the Rocketfish Miracast Video Receiver into the HDMI port
on your TV. If the video receiver will not fit into the HDMI port on
your TV (too large or too wide), use the 6" HDMI adapter for a
better fit.
3
Insert the micro USB connector into the micro USB port on the
receiver. Insert the other end into the USB port on your TV. If the
TV does not have a USB port, use a powered USB charger (not
included).
4
Turn on your TV, then press the TV’s Input or Source button to
select the HDMI input that the Rocketfish Miracast Video Receiver
is connected to.
5
The LED on the Rocketfish Miracast Video Receiver starts to blink
and the boot up splash screen is displayed within 30 seconds. If
the LED doesn’t blink or the boot up splash screen is not seen,
check to make sure that the TV input you have selected is correct
and the Rocketfish Miracast Video Receiver has power and is
firmly connected to the TV.
12-1245_RF-WFD301_MAN_V1_EN.fm Page 7 Tuesday, June 4, 2013 10:36 AM
