20
S
PECIFICATIONS
MODEL- 3SIXTY.1
3SIXTY.2
Maximum Input Level
20 V rms
20 V rms
Maximum Output Level
5 V rms
5 V rms
Output Gain
±10dB
±10dB
Frequency Response
10Hz-21kHz
10Hz-21kHz
Total Harmonic Distortion
<0.01%
<0.01%
Signal to Noise Ratio
-100dB (A-Weighted)
-100dB (A-Weighted)
Input Impedance
10k Ohms
10k Ohms
Crossover Slope
N/A
12/24 db/octave
Crossover Type
N/A
3-way
12dB/Octave Butterworth
24dB/Octave Linkwitz-Riley
Crossover Frequencies
N/A
62 steps/50Hz-10kHz
Subsonic Filter Slope
N/A
12/24 dB/Octave
Graphic Equalization Controls
N/A
31 bands, 20Hz-20kHz
ISO 1/3 octave centers
Equalization Boost/Cut
N/A
±10dB
Power Draw
600mA
600mA
Recommended Fuse Rating
2 Amp
2 Amp
Weight
1.0 lbs
1.0 lbs
Dimensions:
Height
1.75”
1.75”
Width
7.25”
7.25”
Length
4.25”
4.25”
Specifications subject to change without notice
T
ROUBLESHOOTING
Palm Device
Palm locks up or freezes.
A. Perform a soft reset on your Palm by locating the RESET button on the Palm. Please see Palm
owner’s manual for location of this button as it varies from device to device.
When installing the 3Sixty programs onto my Palm, I do not see them listed in the available
applications.
A. When installing new applications, Palm devices typically store them in the unfiled section of your
Palm. You may choose to locate this folder, or may need to set the Palm to view all programs,
please see Palm owners manual for more info.
Palm won’t connect to 3Sixty.
A. Check that 3Sixty is powered up and power indicator is solid, not blinking.
B. Make sure you are using the appropriate software for your hardware, IE 3Sixty.1 software with a
3Sixty.1 device or the 3Sixty.2 software for a 3Sixty.2 device.
C. Make sure Palm is not in DEMO mode (When in this mode, the upper left hand corner of the
screen in the 3Sixty application will show the word DEMO instead of the Bluetooth symbol).
D. Move palm closer to the 3Sixty device, there may be too much metal between the device and the
Palm reducing the signal strength.
E. Verify you have the correct PIN.
When adjusting the EQ, the Palm appears to freeze or lock up.
A. When you adjust the EQ, the Palm will show “Updating…” on the top of the EQ section. This is
an indication that the Palm is still processing your changes. Simply wait and this message should
disappear and Palm will become active. If it does not, you may need to reset your Palm (see Palm
owners manual for more info).
