- 3 -
Installation
Reference
Sheet
RFT4061
RFT4081
RFT4101
6” Box That Rocks
8” Box That Rocks
10” Box That Rocks
Specifications subject to change without notice
RUN THE SPEAKER CABLE FROM THE AMP
When routing the speaker cable from the amplifier,
avoid running it close to any sources of high current
(e.g., wiring harnesses). The positive (+) speaker out-
put from the amp connects to the red terminal of the
enclosure, and the negative (–) connects to the black
terminal.
1. INSTALL THE MOUNTING BRACKETS
Place the enclosure in the desired mounting location and
position the mounting brackets approximately 4” from each
end. Push the mounting brackets as close as possible to the
enclosure without moving or lifting it. Carefully remove the
enclosure and secure the brackets using the supplied screws.
NOTE:
Be careful not to mount the enclosure on cardboard or
plastic panels. Doing so may allow the screws to pull out
from the panel due to road vibration or sudden vehicle stops.
CAUTION: Before drilling, check under vehicle to avoid
damage to brake or fuel lines, etc.
2. INSTALL THE MOUNTING STRAPS
Feed each strap through the pair of mounting brackets and
position the enclosure in place over the straps. Tighten each
strap securely.
NOTE:
Be sure the mounting straps are looped through the
buckle correctly. Check the straps regularly to ensure your
enclosure is securely mounted in place.
WARNING: PLEASE FOLLOW THESE INSTRUCTIONS CAREFULLY. FAILURE TO FOLLOW THESE INSTRUC-
TIONS OR TO INSTALL THE ENCLOSURE PROPERLY COULD RESULT IN DETACHMENT OF THE
ENCLOSURE AND SERIOUS INJURY.
Secure brackets to
floor board
INPUT
-
+
Bridged Amplifier
(4
Ω
)
Black
Red
