6
Once the bolts are removed you will need to pull the dash off of the
chassis.
NOTE: When pulling the dash off you will notice that it still feels
attached. It has several retaining clips on each side that are holding
it in place. Just continue pulling toward the interior of the vehicle
to release the dash from the chassis.
Step 6 - Remove Glove Box
To get the glove box removed, you will first need to remove the
glove box door. Open the door and then push it to the passenger
side of the vehicle. At the same time pull the driver’s side of the
door out to release the retaining stud.
NOTE: Bending the door slightly may be required to get the door
removed.
Installation
Once the glove box door is removed, remove the bolts holding the
glove box in place. There are two above the chassis dash bar.
Remove the glove box from the vehicle once bolts are removed.
Step 7 - Load Subwoofer Into Enclosure
Before mounting the subwoofer enclosure, you will need to load
the subwoofer into the enclosure. The kit contains two wires for the
subwoofer. A main wire that goes to an amplifier and the other is a
jumper for dual voice coil subwoofers.
Reference your subwoofer’s manual
for proper wiring. Failure to wire the
subwoofer correctly can cause damage to
the amplifier and/or subwoofer.
