8
Installation
Step 9 - Replace Center Pocket Bracket
The center pocket bracket will need to be removed and replaced
with a new bracket that comes with the kit.
Attach the new bracket with the existing bolt that previously held
the center pocket bracket.
Step 10 - Install Grab Bar Enclosure Bracket
This next step requires another bracket to be mounted to the two
holes where the factory glove box was mounted.
Step 11 - Install the Loaded Subwoofer Enclosure
Once all of the brackets are installed, the subwoofer enclosure
can now be installed. The enclosure goes into the vehicle with the
subwoofer facing the fire wall and the flat side of the enclosure is
on top. The box needs to inserted up towards the driver’s side of
the vehicle first.
Line up the brackets with the mounting holes and insert supplied
hardware into the enclosure’s mounting holes. Keep everything
hand tight until you get all of the hardware in place.
NOTE: The vehicles wire harnesses that were removed from the
dash top will go between the enclosure and the fire wall. There a
groove on the enclosure where the wires are to be routed.